Aurora Homepage
Forum Home Forum Home > Aurora Sequencer Software > Aurora 1.0 > Bug Reports
  Active Topics Active Topics
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Channel Config bug?

 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
JohnnyL View Drop Down
Pre-Order User
Pre-Order User
Avatar

Joined: 17 Dec 2007
Location: Merced Ca
Online Status: Offline
Posts: 67
  Quote JohnnyL Quote  Post ReplyReply Direct Link To This Post Topic: Channel Config bug?
    Posted: 04 Jun 2009 at 5:46pm
Hi guys, last night i imported a new channel config into all of my sequences. everything went smooth except for for the RGB channels. in the old config i had 1 DCx16 set up as 5 RGB channels. however the new config has 3 DCx16's all setup for RGB. i used 15 channels and left one open on each controller (ch16). i randomly checked the irq and channel numbers to make sure nothing was going weird. all of the ACx16's and fireflys and imported fine but the DC boards did not fare too well. the irq's were "1", "B" and "C" and while the first channel (red) maintained the correct irq and ch # the others (green & blue) were set for different irq and all set to channel 1. it was easy to correct and i thought you should know about it. version is 1_0_41. os is vista.  John
"In God We Trust" all others pay cash
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.06
Copyright ©2001-2007 Web Wiz

This page was generated in 0.390 seconds.