Aurora Homepage
Forum Home Forum Home > Aurora Sequencer Software > Aurora 2.0 > Aurora 2 Beta 1 (1.999.300 / 1.999.307)
  Active Topics Active Topics
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

D-Light/LOR <-> J1/Lynx Adapter Cable Wiring

 Post Reply Post Reply
Author
Message Reverse Sort Order
  Topic Search Topic Search  Topic Options Topic Options
LightsOnLogan View Drop Down
Admin Group
Admin Group


Joined: 11 Oct 2007
Online Status: Offline
Posts: 3187
  Quote LightsOnLogan Quote  Post ReplyReply Direct Link To This Post Topic: D-Light/LOR <-> J1/Lynx Adapter Cable Wiring
    Posted: 26 Nov 2013 at 1:05pm
There are two pinouts for sending DMX over RJ-45 plugs to our controllers.  On one hand you have the D-Light and LOR wiring pinout (for their USB-485 adapters and controllers), and on the other hand you have the wiring pinout used by the Joshua1 Systems and Lynx products.  Whenever you need to connect one of these devices to the other an adapter cable is required. 

There has been much discussion about how to do this elsewhere on the Internet (including debate about the "third wire").  During beta testing we took the opportunity to test out various cable configurations and have come up with this "official" pinout diagram that proved to be the best to use when making adapter cables:



This cable can be use in either direction (it is not end specific) and it does include the debated third wire that some controllers do make use of.  We highly recommend using this wiring for your adapter cables.

Also, there is a "jumper mod" for the DR4 circulating around the Internet which is supposed to make the DR4 jacks be wired into the D-Light/LOR configuration.  We do not recommend doing this modification to the DR4.  We highly recommend using the above adapter wiring instead.

Michael
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.06
Copyright ©2001-2007 Web Wiz

This page was generated in 0.266 seconds.