Aurora Homepage
Forum Home Forum Home > Aurora Sequencer Software > Aurora 1.0 > Bug Reports
  Active Topics Active Topics
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Controller disconnects while playing

 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
kennyz06 View Drop Down
Newbie
Newbie
Avatar

Joined: 05 May 2008
Location: Texas
Online Status: Offline
Posts: 24
  Quote kennyz06 Quote  Post ReplyReply Direct Link To This Post Topic: Controller disconnects while playing
    Posted: 06 Aug 2009 at 9:51am
I was testing out one of my LOR PC controllers last night and noticed that when I test my show, it will randomly disconnect the controller in the middle of the show.
 
When I say it disconnects, I mean that the red led begins to flash durring the show.  It will start off fine, and then start flashing.  I havent tested it with other sequences yet, but I'd say its an issue if it even does it on one sequence.
 
I'm running version 4.3 on the LOR board, and 1.69 of Aurora.  Its an amd single core pc with 1gb of ram... running windows 7.
 
Also, what baud rate should I be using for this? 56k?
 
Thoughts? 
Back to Top
LightsOnLogan View Drop Down
Admin Group
Admin Group


Joined: 11 Oct 2007
Online Status: Offline
Posts: 3187
  Quote LightsOnLogan Quote  Post ReplyReply Direct Link To This Post Posted: 07 Aug 2009 at 8:13am
To answer the baud question: 56000 is the "official" spec, however both LOR and D-Light are designing their controllers to handle 115,200 these days.
 
Now for the more difficult one, the controller that is losing heartbeat:
 
1) Is this happening with Aurora or Borealis?
 
2) Can you test by isolating to just one controller on a short Cat-5 cable just to make sure there isn't a cable issue?
 
Back to Top
kennyz06 View Drop Down
Newbie
Newbie
Avatar

Joined: 05 May 2008
Location: Texas
Online Status: Offline
Posts: 24
  Quote kennyz06 Quote  Post ReplyReply Direct Link To This Post Posted: 07 Aug 2009 at 8:31am
I'll test it this evening, but I know the cable is good.  Also, it's only one controller I'm testing. 
 
The problem occurs in Aurora, I have not checked Borealis.  I'll do that this evening
Back to Top
kennyz06 View Drop Down
Newbie
Newbie
Avatar

Joined: 05 May 2008
Location: Texas
Online Status: Offline
Posts: 24
  Quote kennyz06 Quote  Post ReplyReply Direct Link To This Post Posted: 07 Aug 2009 at 5:25pm
Problem solved.  I had the usb adapter connected to my monitors usb port.  I plugged it right into the pc and it works fine now.  Sorry!
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.06
Copyright ©2001-2007 Web Wiz

This page was generated in 0.172 seconds.