Lights firing at the wrong time.
Printed From: Aurora
Category: Aurora Sequencer Software
Forum Name: Aurora 1.0
Forum Discription: This is the place to discuss (and report bugs) the 1.0 version of Aurora
URL: http://www.aurorashow.com/forum/forum_posts.asp?TID=628
Printed Date: 01 May 2025 at 8:50pm
Software Version: Web Wiz Forums 9.06 - http://www.webwizforums.com
Topic: Lights firing at the wrong time.
Posted By: HarleyHaynes
Subject: Lights firing at the wrong time.
Date Posted: 21 Dec 2008 at 9:41pm
| I have an almost complete sequence but when I test it through Aurora it has 2 channels firing at the same time when I have clearly made sure they should not be firing at the same time. I first thought this was an issue with ramps so I turned all the ramps to on an still getting the same problem. It only happens during one small part of the sequence. When viewing in visualizer it seems fine but when I send to lights is when the issue begins. It only seems to be 2 channels doing this as well. Rest of the sequence seems to run fine. At first I thought I had a couple of channels plugged in to the wrong output cords but when I check in hardware utility everything seems fine. |
Replies:
Posted By: Jonathan
Date Posted: 21 Dec 2008 at 10:44pm
|
What kind of strands are misfiring? Are they LED's? What version of Aurora are you using? (1.0.41?) Does this also occur in Borealis Scheduler, or just the sequencer? ------------- ~Jonathan |
Posted By: HarleyHaynes
Date Posted: 30 Dec 2008 at 10:31pm
I got the issue worked out. Newbie I D 10 t error 
|